balanced input การใช้

• This is avoided by using a balanced input and output also known as push-pull amplifier.
• It is the equivalent to a very high gain amplifier with well-balanced inputs and controlled output limits.
• High quality balanced inputs completed each amplifier.
• Many other components, such as graphic equalizers and effects units, have balanced inputs and outputs to allow this.
• "You need a balanced input approach, " said Jim Schroer, executive vice president of product development and quality.
• An, isolated and balanced input.
• A balanced input, non-isolated.
• Most audio products ( recording, public address, etc . ) provide differential balanced inputs and outputs, typically via TRS phone connectors.
• An isolated and quasi-balanced input ( the floating common is typically connected to the (-) input of a differential amplifier ).
• However, in most cases, a differential balanced input signal is internally converted to a single-ended signal via transformer or electronic amplifier.
• The Revox variants were designed for consumer use, with features such as IR remote control, and the omission of balanced input / output sockets.
• The term is not used for logic circuits producing complementary outputs, nor applied to differential amplifiers that have balanced inputs " and " outputs.
• This made the phono and balanced inputs on the unit shared, only one set could be active in the unit based on which board was present.
• There were hardware alterations made to the TI such as the newly added balanced inputs / outputs, 24 bit / 96 kHz output and the new sequencer integrated interface.
• M-and P-cells receive relatively balanced input from both L-and M-cones throughout most of the retina, although this seems to not be the case at the fovea, with midget cells synapsing in the P-laminae.
• Circlotrons, unlike minimalistic single-ended amplifiers, need to employ quite complex balanced input and driver stages delivering at least 100V peak-to-peak voltage " and " able to drive relatively high capacitance loads ( due to the number of paralleled power triodes and associated long wiring ).
• Many types of coaxial cable have a characteristic impedance of 75 ?, which would therefore be a good match for a half-wave dipole, however coax is an unbalanced transmission line ( with one terminal at ground potential ) whereas a dipole antenna presents a balanced input ( both terminals have an equal but opposite voltage with respect to ground ).